What can you do with a crap ton of holy (hole-y) t-shirts that you can’t wear anymore without looking like a hobo? You make t-shirt yarn!! And it is so easy. Here are the steps on making your own t-shirt yarn.
What you will need:
X-acto knife or scissors
Hard surface that you can cut on (I cut over card stock)
1. Find t-shirts. I found that shirts with a silk screen print doesn’t curl as easy in the final step.
2. Fold the shirt like below. The top half is about an inch shorter at the top than the bottom half.
3. Cut the bottom inch off the shirt (actually the right side) – but it is really the bottom of the t-shirt. A scissors worked better than a x-acto knife I found out.
4. Next you will cut 1 inch or 1.5 inch slits starting from the right, moving to the left. Cut only up to the top edge, leaving that 1 inch gap uncut. (see below)
5. You will end right below the sleeve/arm pit. You will cut all the way across here.
6. Lift up the side of the shirt that was left uncut. Spread it open over your forearm.
7. You will start cutting into one long strand of yarn now. Starting on the right side, closest to your fingers. Place the scissors on the outer side and you will cut a diagonal slice to the first cut.
8. Then you will continue to cut diagonal, the most right bottom cut, to the next top cut. Stay parallel to your first cut.
9. Continue all the way to the left. The last bottom slit on the left side you will have to end the cut on the outermost edge. Similar to how you started, just reverse.
10. That was your final snip. You have one long strand of yarn now. You will have to stretch it so it curls. Start on one edge and lightly stretch it so the fabric naturally curls.
11. Finally, just roll it into a ball until you are ready to knit with it. A scarf made out if this yarn would be super soft and warm! If you do not have t-shirts laying around, check out a thrift store. They probably receive a lot of shirts they cannot sell because of bleach stains or maybe some small holes.